[. . . ] Rotate the release handle back and forth while moving the hole in the plate lock until the handle key (1) is firmly seated in the hole. Place the scanner on the shelf, making sure the foot on the right front of the scanner engages the release plate (1) on the shelf. First screw: Pull the safety lever (a) back to expose the hole in the shelf. Insert one medium screw up through the hole and into the scanner, then tighten the screw (1). [. . . ] Insert one medium screw up through the hole and into the scanner, then tighten the screw (1). Remaining three screws: Attach as follows: left front (2), left rear (3), and right rear (4). Slide the scanner lock (on the left side of the scanner) to the UNLOCK position. When moving the scanner stand with the scanner attached, be sure the scanner is attached to the underside of the stand with all four screws. Do not tilt the stand where the scanner top could shift the weight of the scanner. Attach the scanner power supply (see "Accessories in Scanner Box" on page 14) to the keyhole inside the back of the stand. Lift the ADF paper tray, then extend the legs and lower the tray into position. Connect the scanner power cable (see "Accessories in Printer Box" on page 5) to the scanner power supply. NOTE If you are installing the optional finisher with the system, see the instructions provided with the finisher. Attach the power strip (see "Accessories in Printer Box" on page 5) to the lower left side (viewed from the front) of the scanner stand using the two screws provided in the printer box. Using a Web Browser (optional) Use your web browser to configure print server and printer menu settings on an embedded web page. 2 Click on the utilities and downloads you want to install and follow the instructions. Activate Printer Options You can configure the options manually or, for TCP/IP network connections, you can configure the options automatically using the Two-Way Communications feature. To Configure PostScript Driver Options Automatically If you have a TCP/IP enabled network, you can automatically update your printer driver to reflect the options currently installed on the printer. Test the Printer Driver Installation To make sure the printer driver is correctly installed, print a page from any program. Click on the utilities and downloads you want to install and follow the instructions. If your printer has an optional second paper tray, duplex unit, hard disk drive, or additional memory installed, you must open the printer driver and activate the device. Use the Web Page to Configure the Printer If you are working in a TCP/IP-enabled environment, you can use a web browser to display the printer or job printing status and to change settings. settings for the system and network ports can be configured under [Printer] , [Network] and [Maintenance] on the web page. Note:The web page facility is only available when the printer is connected to the network. [. . . ] settings for the system and network ports can be configured under [Printer] , [Network] and [Maintenance] on the web page. Note:The web page facility is only available when the printer is connected to the network. Connect the USB cable Note:Printer operation is not assured if another USB compatible device is connected concurrently with it. Every effort has been made to ensure that the information in this document is complete, accurate, and up-to-date. [. . . ]